Case Study of Swedish Telecommunications Equipment Room Construction
In this paper, we analyse the standardisation and building of the Nordic mobile telephone system (NMT) as practical design work.
Read More
Fiber optic communication equipment in power distribution room
Communication networks are an integral part of interconnected transmission lines in a power grid, analogous to the spinal cord for control signal and information exchange among substations, data h.
Read More
Electrical Equipment XM Distribution Box
XM series integrated distribution box/cabinet is suitable for AC frequency 50Hz, rated voltage 220V or 400V single-phase or three-phase five-wire lighting and small power lines, it is used to control, distribute, and meter electrical equipment, and to protect against overload . XM Cabinet is widely used in lighting distribution systems of power station,transformer station,factory,mine,hotels,apartment,buildings,port,railway station,airport,warehouse,hotels etc. Both recess mounting and indoor wall mounting can be supplied according to customer requirement.
Read More
Standards for Fiber Optic Cable Laying in Communication Equipment Rooms
163 describes criteria for the installation of optical fibre cables defined in Recommendation ITU-T L. (FOA) was founded in 1995 to help develop the workforce to build the fiber optic networks to support a rapid expansion in communications and the Internet. Recommendations for Fiber Optic Cable Installation Where reels are supplied with protective material fitted over the cable, the protection should remain in place until the cable will be installed. ' The Fiber Optic Association (FOA) recently published a standard titled "FOA Standard For Installing Fiber Optic Cable Plants. Existence of a standard shall not preclude any member or nonmember of NECA or FOA from specifying or using.
Read More
Precautions for fiber optic cable splicing in equipment rooms
The top ten things a fibre optic splicing engineer should consider when working safely include wearing appropriate PPE, using proper handling techniques, properly labelling and identifying cables, verifying power sources are disconnected, using proper lighting, following industry. he fiber be examined with an eye-loupe for a satisfactory cleave, only an eye-loupe contain opriate filter shall be used. Introduction This Program provides supervision, employees and safety managers with general safety rules, task safety procedures and best techniques for installation of quality fiber optic cable systems (cable handling, splicing, pulling, terminating testing and trouble shooting tasks). The best way to protect people is to eliminate the hazard or risk and second best, minimize it. All areas used by the public shall be maintained free from debris or equipment that may constitute slipping, tripping, or any other hazard. Before splicing, according to the material and type of the optical fiber, set the key parameters such as the optimal pre-melting main melting current and time, and the amount of fiber feeding. This document describes some basic safety information applicable to Optical fiber cable installation & storage.
Read More