NMR is widely used in organic chemistry and industrially mainly for analysis of chemicals. The technique is also used to measure the ratio between water and fat in foods, monitor the flow of corrosive fluids in pipes, or to study molecular structures such as catalysts. The application of nuclear magnetic resonance best known to the general public is.
Read More
IEC 62003:2020 establishes requirements for electromagnetic compatibility testing of instrumentation, control, and electrical equipment supplied for use in systems important to safety at nuclear power plants and other nuclear facilities. The potential for disruption of safety-related I&C systems by electromagnetic interference (EMI), radio-frequency interference. This regulatory guide has been revised to provide guidance to licensees and applicants on additional methods acceptable to the NRC staff for.
Read More
These devices safeguard assets and maintain power stability by swiftly detecting and isolating faults. This guide explores the different types of protection relays and their testing procedures, with a focus on tools like secondary injection test sets and three-phase relay test sets. Long term cost reduction (TCO) for trainings and maintenance by reduce variety of relays A fast and selective arc fault mitigation for air-insulated LV & MV switchgear and Relion protection and control relays and sensor. A special type of relay is one which monitors the current, voltage, frequency, or any other type of electric power measurement either from a generating source or to a load for the purpose of triggering a circuit breaker to open in the event of an abnormal condition.
Read More
Technicians use various tools to install, maintain, and troubleshoot fiber cabling: detection and verification testers, certification testers, inspection cameras, cleaning supplies, certification testers, and advanced optical time domain ref. Fiber optic cable is a type of cabling that contains one or more optical fibers for transmitting data at high speeds and/or over long distances using light. These fibers are most commonly made of glass and are very thin, typically less than a tenth of the width of a human hair. It encompasses all of the standards, processes, and tools used to test the components of both newly installed and deployed fiber optic networks, in. Because fiber end faces are so small, contaminants that are too small to be seen can disrupt communications.
Read More+27 10 247 8396
Unit 7, Summit Place, 21 Summit Rd, Midrand, Johannesburg, 1685, South Africa